![]() ![]() It includes: structural calculation report, construction drawing with bar schedule, material quantities and 3D CAD. AFES is software for raft foundation design. In each case the controlling load combination is identified and reported. GS Engineering & Construction AFES (Automatic Foundation Engineering System) is a comprehensive software which is used for designing and analyzing of. Output The program checks the footing stability in overturning, sliding and uplift for the service combined loads, and performs the concrete design, which includes the one-way shear, punching shear and bending for the factored combined loads. Model a single set of pre-combined loads. All design parameters are shown in table 1. ![]() In this special project the method used in the design called the Conventional Rigid Method and all design steps will be shown in the report. Raft foundation can be design using several methods. In addition, the software accepts a number of load cases, such as dead, live, snow, wind, and seismic to be combined internally. All analysis and design are based on the ACI code. ![]() Input The required input data includes the footing and column dimensions, materials’ properties, allowable soil bearing pressure, and acting service and factored loads. This is especially useful when a footing with small vertical load and big moments is being designed, such as a footing at the corner of a building under lateral loads. My spring constant was always KsP/Delta, or the pile capacity divided by the expected settlement of the pile. In the past, Ive used a point spring to represent the piles. I exported the model and the loads from RSS, but now Im trying to model the piles. The pressures may also be calculated when only a part of the footing is in contact with soil (partial bearing). Im designing a mat supported on piles in Concept. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |